Mixer Whisk Stainless Steel 6 Wire – KW717142

Introduction

This is the whisk for some Kenwood mixers. Replaces KW712212.

• Genuine Kenwood mixer whisk
• Stainless steel
• 6 wire whisk
• Balloon whisk
• Bayonet Hub
• Non-Circlip Shaft; if your mixer has a circlip shaft you will also need to purchase part KW711986.

It is important that you adjust the height of your Kenwood attachment before using it in your machine.

Adjustment instructions:

1. Unplug the mixer
2. Raise the mixer head and insert the whisk or beater
3. Hold the attachment, then loosen the lock nut on the shaft
4. Lower the mixer head
5. Adjust the height by turning the shaft. Ideally the whisk/K-beater should be almost touching the bottom of the bowl
6. Raise the head, hold the whisk/K-beater and tighten the lock-nut.